6 replies to this topic

[kstbts]

I'm trying to edit an esword bible module, but I can't seem to open the entire module.  I get Gen to part of 2kings but that's it.  Yet all is present in the esword software.  Any ideas?

[BH.]

Can you post the module here so we can look at it?

[kstbts]

I downloaded the OJB from this site  http://www.biblesupp...h-biblebblxexe/

 

Is that what you mean?  

 

Then using ToolTip, I tried to open it to read it, but it only loads up to 1 Kings. 

[BH.]

There are 2 issues:

 

[1] Did it end on 2 Kings 15:19?  I found an issue in the file where there is a "}" where it should be a "]" on that verse which would invalidate the RTF data afterwards.  It appears that this is the only issue with the file. 

 

[2] The latest e-Sword has a slight variation in the RTF header that prior versions, which makes reading RTF leading to erroneous or no data IF, you have the e-Sword macros installed. 

 

Solutions:  [1] Read the BBLX file record by record by adding a new BBLX reading routine ( only requires a couple of edits in T3), [2] edit the BBLX file for the record for 2 Kings 15:19, [3] and fix RTF header to be e-Sword version independant, which is also a simple change in T4. 

 

I'll post a new update to T4 soon.  Or, you can use a SQLite3 file editor and "fix" the record for 2 Kings 15:19.

[BH.]

I should add, if you look at 2 Kings 15 in e-Sword, the chapter is truncated at verse 19.  The record for 2 Kings 15:19 in the BBLX file is bad.

[BH.]

I have edited the BBLX file and it can be downloaded here:

 

https://www.dropbox....Bible.bblx?dl=0

[BH.]

Oh - and T4 has been updated.