4 replies to this topic

[berwi]

Good afternoon everyone,

 

I meet (suddenly) a problem in converting an rtf file in a bblx-file using

the Nttooltip tool 2.1.3. I . OS=W8.1. As I did many times before with much pleasure.

 

After I give the usual instruction (modules--> bible--> save. Chapter.verse-2nd option)

I receive the notice as you can see in the screenshot. After I close this notice a new one pops up with the same text, only for the second line ( #define abbreviation) after this the third, until and with the line #define font=DEFAULT.

 

I retyped these lines, but with no result.

Thereafter I started the computer anew and installed the program anew, only with the same result.

This is all I could. Can soembody help me?

 

Kind regards

ben

 

P.s I am not sure whether tne sceenshot was correct uploaded. If noy let me know, please

Attached Files

•  140917-001.jpg   128.51K   33 downloads
•  140917-001.jpg   128.51K   36 downloads
•  140917-001.jpg   128.51K   23 downloads

[Katoog]

#define description=Profeten

And push on enter or return

Because I think that it is a "soft return" instead of a "hard return"

press on ¶ to see that you are using "hard return"(¶) or soft return(¬)
You need a "hard return"

 

 

Probeer een introductie te maken zonder duidelijke spellingsfouten zoals "daaarna" en "naamvals".

Edited by Katoog, 17 September 2014 - 09:58 AM.

[DSaw]

I noticed that Isa 1:1 the Mark ÷ is missing on your reference

[BH.]

I concur with DSaw, go to the line with Isa 1:1, and press Ctrl+M to add the division mark, and try again.

[berwi]

Yes, the 3 and the 2 tip gave the solution of the problem. The 1 tip I will also keep in mind.

I must have a sort of blackout, for I did know this. Sorry to have bothered you. Thank you for the help.

Kind regards

Ben