2 replies to this topic

[richardchouinard]

Hi,

When creating BBLI file, is it possible to remove the default space after paragraphs (verses)? I think it is set to 5pt.

Thanks,

[Katoog]

I do not understand the 5pt part because it in not about the font side.

e-Sword supports only verse per line format. (not the text-bock format aka paragraph format that remove the verse numbering lines.)

So you need to use a "hard return"(Enter) at the end of every verse.

There is no space needed after the last . or ? or ! at the end of the verse.

You can remove "Double Line Feed Charts" with ToolTipTool in the Tool menu.

 

However, you can use a "soft return"(Shift+Enter) to create line-breaks or paragraphs or semi-paragraphs as I do in my translation.

Edited by Katoog, 06 December 2019 - 01:28 AM.

[richardchouinard]

I do not understand the 5pt part because it in not about the font side.

e-Sword supports only verse per line format. (not the text-bock format aka paragraph format that remove the verse numbering lines.)

So you need to use a "hard return"(Enter) at the end of every verse.

There is no space needed after the last . or ? or ! at the end of the verse.

You can remove "Double Line Feed Charts" with ToolTipTool in the Tool menu.

 

However, you can use a "soft return"(Shift+Enter) to create line-breaks or paragraphs or semi-paragraphs as I do in my translation.

 

Sorry, my question was not clear.

 

Because there is a "hard return" at the end of every verses, each verse is like a "paragraph". I understand that it have to be like that.

 

With previous versions of e-Sword, using RTF modules, there was no gap between verses (no space between paragraphs), or maybe a very small one. A chapter looked almost like a "single line spacing" text.

 

Now, the gap between verses is bigger. So in the same window size, I can see fewer verses than before.

 

Is there a way to adjust that gap?